DO NOT RETURN THIS PRODUCT TO THE STORE OR WEB SITE YOU PURCHASED IT FROM! IF YOU BELIEVE THIS MOUNT IS DEFECTIVE, HAS MISSING OR BROKEN PARTS, OR IF YOU ARE HAVING DIFFICULTY INSTALLING THIS MOUNT TO YOUR WALL OR FITTING YOUR TV, PLEASE CONTACT OUR COMPANY, LEVEL MOUNT, DIRECTLY.ĭial 1 8 or email us at any time of the day or night for a quick and efficient solution to your problem. Our trained Customer Service Department is open 24 hours a day, 7 days a week, every day of the year and is prepared to assist you in both English and Spanish. V M5 x 48 Bolt 8 7* W M5 Hex Nut 8 X M5 Washer 8 Y L-Shape Bar Lock 2 8 Z Phillips screws M5 x 10 Bolt 4 AA M5 Hex Nut 2 BB M5 Butterfly Nut Please also visit our Web Site at for assistance. Tools required for attachment to stud: 1/2’’ (12mm) Socket Wrench Stud finder Tools required for attaching to concrete: Electric drill 1/2’’ (12mm) Masonry BitĬAUTION: Installer must make sure the LCD Wall Mount is proper- ly and securely attached and that appropriate fasteners are used. It is the responsibility of the installer to verify that the mount is anchored properly to the wall. PLEASE NOTE: THE MOUNT MUST BE ATTACHED TO WOOD STUDS OR TO PROPERLY INSTALLED ANCHORS IN CONCRETE. This unit will pan up to 30, extend up to 6.5. Before installing, check to make sure all parts of the mount are included. Easy to use and install, this Level Mount DC37SJ is designed to fit any 10-40 LCD or Plasma TV up to 100 lbs. Make sure all screws and bolts are tightened before allowing Wall Mount to bear the full weight of the LCD Display.Īttaching Wall Plate to Wooden Studs: 1a. Locate wall studs: Locate a proper place to mount by LEVEL MOUNT BY ELEXA INSTALLATION FULL Using the included stud finder (Figure 1) It is recom- mended that the center of the stud be used – and that a nail be used to verify that a stud has been located. The mount requires a minimum of two studs to ensure proper and safe installation. The tilt arms will adjust horizontally to the right and left up to 8 inches after you determine the desired viewing location.Īttaching LevelMount to wall: Once the Wall Plate is in the correct position on the studs, screw 1 Hex Screw and 1 Hex Washer (P & Q) in the upper left mounting hole of the Wall Plate into the stud. Do not screw too tight until after all the screws are in. Drill pilot hole with 1/8 inch drill bit. Using the Bubble Level as your guide (Figure 3, page 2), drive the 2nd screw into the opposite upper right hand mounting hole of the Wall Plate. Now tighten both screws, proceed to drive the remaining 2 screws into the studs as seen in figure 2, page 1.
0 Comments
Leave a Reply. |